Payne Furnace Code 11
StatusShown as: 1 short flash, 1 long flash
No previous code. Nothing is stored in the control's fault memory; stored codes erase automatically after 72 hours.
Manual wording: “11 NO PREVIOUS CODE - Stored codes are erased after 72 hours. Run system through a heating or cooling cycle to check system.”
Documented for: PG92ESA, PG95ESA, PG96VTA
Likely causes, most common first
- Normal - no stored fault
- A previous fault aged out after 72 hours or was manually cleared
What you can safely check yourself
- Nothing to fix - run the furnace through a full heating cycle and see whether a real code appears
When to call a technician
If the furnace misbehaves but only shows 11, a technician should watch a live cycle to catch the fault as it happens.
A Payne furnace throwing this code repeatedly has a reason — clearing the code without fixing the cause just hides it.
Sources
- PG92ESA: Installation, Start-up, Operating and Service and Maintenance Instructions (Payne, PG92ESA multipoise 92% single-stage condensing gas furnace) · checked 2026-08-25
- PG95ESA: Installation, Start-up, Operating and Service and Maintenance Instructions (Payne, PG95ESA multipoise 95% single-stage condensing gas furnace) · checked 2026-08-25
- PG96VTA: Installation, Start-up, Operating and Service and Maintenance Instructions (Payne, PG96VTA two-stage, variable-speed ECM 4-way multipoise condensing gas furnace) · checked 2026-08-25